Assembly Demo: GK2007 Trade Show Assembly

Transcription

Carefully take the modular frames out of the shipping box.

Helpful Tip: Lay out each frame, number side down, in chronological order following the numbers located on the bottom of each panel.

Stand the first two connecting frames up and arrange frames side by side, placing one panel slightly higher than the other. Slide the slightly higher panel down, guiding the tabs to click into place.

Push the pin into the hole of the connecting frame to secure and lock the panels together.
 
Continue to connect the remaining frames using the same method until you have reached the last frame.

Repeat this process for all the remaining frames. 

For the counter assembly, start by standing the door panel up first arranging one of the side panels alongside the channel. Using the same assembly method as the backwall, connect each panel.

Next, add the shelf supports by attaching the velcro side to the velcro side on the inside part of the hinge connectors and then add the shelf.

Next add your graphics to the counter. Be sure to do this before adding the countertop. Apply your graphics. You may choose to fast-forward to the graphic application section of this video here and come back. 

When adding the countertop, make sure the wood extrusions on all 4 corners fit into the inside of the frames.  Then slide the latch on each side to secure it in place.

Next you’ll add the shelves on the interior of the closet.  Before you do, you’ll need to loosen the clamps on the back of each shelf to so that it expands and has give. This will allow you to slide the clamp into the adapter. After aligned and leveled, secure in place by re-tightening. 

Now add the remaining shelves in place.  Feel free to position them in the configuration that works best for your needs.   

Helpful Tip: Use a level to ensure your shelves are tightened into place evenly. 

Next, grab your SEG graphics, located in the booth crate and install each panel using the “opposite corner” method.

This means to start the silicone edge at the bottom left corner getting a small stretch secured and then moving on to the alternate corner to get that corner started.

Repeat with remaining corners. Lastly, move on to finish each side. (See steps in depth later in video.)

Remember to push the edge into the channel, don’t pull. Pushing the welt into the channel is much easier and allows proper distribution of the graphic. 

SEG Graphic Installation

To install the graphic, turn the edge of the graphic so the silicone welt is perpendicular to the face of the graphic.  Insert the narrow side of the welt with fabric to outside into the channel.  Repeat for the other side of this corner.

Repeat Step 1 for opposite corner C then insert corner B, followed by corner D, to complete the installation of the corners.

Once all corners are inserted, press one silicone edge into channel from corners and work toward the center.  Make sure welt is fully inserted into channel.  Continue until all sides are done.  Smooth out edges of graphics.

To attach lights to the frame, lock clip into groove of horizontal extrusion, the light will then rest into place. Repeat the same steps for additional lights.

To install the handle, feed one side through the hole on the graphics side.  Then make sure it fits into the inside handle hole for a perfect fit.  Don’t forget to tighten the screws to secure handle.

To install the TV mount, unscrew stand-off barrels from extrusions.  They should screw back in over the graphic followed by the monitor mount (video to follow)

Now screw the mount into the stand-off barrels that's over the graphic.  Do this for each barrel.  Use the level on the mount to keep your TV level.

Add your mounting brackets to the back of the TV.  Use the mounting holes and line them up with brackets and then screw them in with the provided screws.

You can now hang your TV onto the mount by placing the hooks on to the top lid of the wall mount.

Congratulations!  You have just set up your trade show display for your next event.  For more information, give our rentals team a call at 1-888-492-1885!