Assembly Demo: GK2009 Trade Show Assembly

Transcription

Carefully take the modular frames out of the shipping box.

Helpful Tip: Lay out each frame, number side down, in chronological order following the numbers located on the bottom of each panel.

Stand first two connecting frames up and arrange frames side by side, placing one panel slightly higher than the other. Slide the slightly higher panel down, guiding the tabs to click into place.

Push pin into the hole of the connecting frame to secure and lock the panels together.

Continue to connect the remaining frames using the same method until you have reached the last frame.

Next, grab your SEG graphics, located in the booth crate and install each panel using the “opposite corner” method. This means to start the silicone edge at the bottom left corner getting a small stretch secured and then moving to the alternate corner to get that corner started. Repeat with remaining corners. 

Lastly, move on to finish each side. (See steps in depth later in video.) Remember to push the edge into the channel. 

To attach lights to the frame, lock clip into groove of horizontal extrusion, the light will then rest into place. Repeat the same steps for additional lights.

Congratulations!  You have just set up your trade show display for your next event.  For more information, give our rentals team a call at 1-888-492-1885!