Product Assembly: Trade Show SEG Backdrop Wall

Transcription

TEXT: "20’W Backlit trade show backdrop custom printed SEG graphics assembly video. 
1. Lay out all your pieces like so. 
2. Start with a corner being sure to match the labels. Grab 2 L-Brackets. Unlock the L-Brackets. 
3. Slide into slot in corner pieces. 
4. Connect the 2 corner pieces. 
5. Now lock L-Brackets in place. Tighten the 2 screws on each L-Bracket. 
6. Move on to a side piece. Remove screws and washers and set aside. Insert connectors into place. Now reattach screws and washers. 
7. Repeat these steps attaching remaining frame pieces.
8. Now connect the horizontal support beam using the straight connectors. Finish connecting remaining pieces. 
9. Now connect the vertical support beams. Attach assembled vertical beams to corresponding positions on frame and horizontal beam by tightening the screws. 
10. Grab the LED strips and lay them out in the frame. Connect LED strip to the frame. 
11. Next grab the plastic locking tabs and attach the LED strips to the frame. The cord goes up the side of the frame and connects to the following LED strip. Secure the cord in place with plastic locks. Repeat all around the frame as shown. 
12. Now it’s time to attach the feet to the frame by using the provided screws and bolts. Finish by fully tightening with a hex key. 
13. After attaching all the feet, lift the frame upright. You can now attach the power supplies and plugs. 
14. Lay frame flat to install SEG. Start on a corner first. Be sure to fold the silicone edge in and insert it into the slot. Pull the SEG tight and install the next corner. Be sure to do all corners first to get a nice even tight fit. 
15. Now you can install the rest of the SEG.
16. Stand your SEG wall upright."